Caltrans Office Engineer

Viewing inquiries for 03-2F3004

Submit new inquiry for this project


Inquiry #1: under cold planing item in special provisions,you specify 1/4" tool spacing on cold planers. If enforced,this will greatly effect production,therefore the cost of the job.this spec has been used in the past,but not enforced. please indicate if this will be enforced and how, so everyone can bid the job equally.
Inquiry submitted 10/08/2012

Response #1:10/8/12: Your inquiry has been received and is being reviewed. Thank you for your patience.
Response posted 10/08/2012


Response #2:10/8/12: Please bid per the current contract documents.
Response posted 10/08/2012






The information provided in the responses to bidder inquiries is not a waiver of Section 2-1.03, “Examination of Plans, Specifications, Contract, and Site of Work,” of the Standard Specifications or any other provision of the contract, nor to excuse the contractor from full compliance with the contract. Bidders are cautioned that subsequent responses or contract addenda may change a previous response.