Caltrans Office Engineer

Viewing inquiries for 03-2F2604

Submit new inquiry for this project


Inquiry #1: Bid item #9 seems unclear. Removal and replacement. Please advise as to what is expected with regards to. I am seeing it as applying the details on sheet #9 to the existing k-rail and leaving the k-rail in its current location.
Inquiry submitted 07/12/2012

Response #1:7/12/12: Your inquiry has been received and is being reviewed. Thank you for your patience.
Response posted 07/12/2012


Response #2:7/13/12: As shown on sheets L-2, C-1 and C-3, there is existing temporary railing (Type K) in place. Sheet C-3 shows the existing temporary railing (Type K) as pinned. Please refer to the "NOTE" under "Temporary Railing (Type K)" shown on sheet Q-1. In the process of completing the work, it is anticipated that the contractor may need to remove the existing temporary k-rail and then replace it in the same position upon completion of the work.
Response posted 07/13/2012




Inquiry #2: What is the location af the final placement of the K-rail? Is it intended to be installed in the same location as the existing K-rail, or does it get moved to the toe of the anchored mesh slope?
The existing K-rail is approximately 350' to 400' in length. Is the final placement to include additional K-rail provided by the contractor or others?

Inquiry submitted 07/13/2012

Response #1:7/13/12: Your inquiry has been received and is being reviewed. Thank you for your patience.
Response posted 07/13/2012


Response #2:7/16/12: Please refer to the supplemental response to Inquiry #1.
Response posted 07/16/2012






The information provided in the responses to bidder inquiries is not a waiver of Section 2-1.03, “Examination of Plans, Specifications, Contract, and Site of Work,” of the Standard Specifications or any other provision of the contract, nor to excuse the contractor from full compliance with the contract. Bidders are cautioned that subsequent responses or contract addenda may change a previous response.