Viewing inquiries for 07-1W5804

Submit new inquiry for this project


Inquiry #1: The installation of the joint seal required full fwy closure. the closure chart does not indicate any time for full closure. Please advice.
Inquiry submitted 01/07/2014

Response #1:For the type of joint seal to be used in this contract, the contractor may make 1 field splice per joint if authorized. Also, if authorized, additional location can be spliced at lane line.

See Standard Specifications 2010, Section 51-2.02C(2), paragraph 3 (page 604):

You may make 1 field splice per joint if authorized. Splice locations and methods must be authorized.
Seals must be manufactured full length and then cut at the splice location and rematched before splicing.




Response posted 01/08/2014






The information provided in the responses to bidder inquiries is not a waiver of Section 2-1.03, “Examination of Plans, Specifications, Contract, and Site of Work,” of the Standard Specifications or any other provision of the contract, nor to excuse the contractor from full compliance with the contract. Bidders are cautioned that subsequent responses or contract addenda may change a previous response.