| TEST NO. |
TITLE OF TEST METHOD |
CONTACT |
| 301 |
Resistance "R" Value of Treated and Untreated Bases, Subbases and Basement Soils (Stabilometer) |
Contact |
| 302 |
Method of Test for Film Stripping |
Contact |
| 303 |
Centrifuge Kerosene Equivalent and Approximate Bitumen Ratio (ABR) |
Contact |
| 304 |
Preparation of Bituminous Mixtures for Testing |
Contact |
| 305 |
Swell of Bituminous Mixtures |
Contact |
| 307 |
Moisture Vapor Susceptibility of Bituminous Mixtures |
Contact |
| 308 |
Bulk Specific Gravity and Weight Per Cubic Foot of Bituminous Mixture |
Contact |
| 309 |
Theoretical Maximum Specific Gravity and Density of Bituminous Paving Mixtures |
Contact |
| 310 |
Determination of Asphalt and Moisture Contents of Bituminous Mixtures by Hot Solvent Extraction |
Contact |
| 312 |
Designing and Testing Classes "A" and "B" Cement Treated Bases (Test method is currently inactive - refer to contact for further information) |
Contact |
| 330 |
Residue by Evaporation of Emulsified Asphalt |
Contact |
| 331 |
Residue by Evaporation of Latex Modified Asphalt Emulsion |
Contact |
| 332 |
Recovery from Deformation of Latex Modified Asphalt Emulsion Residue |
Contact |
| 337 |
Determining the Effect of Heat and Air on Asphaltic Materials |
Contact |
| 338 |
Determination of Cement or Lime Content in Treated Aggregate by the Titration Method |
Contact |
| 339 |
Field Test for the Determination of Distributor Spread Rate |
Contact |
| 341 |
Measuring the Permeability of Bituminous Pavements and Seal Coats |
Contact |
| 342 |
Surface Skid Resistance with the California Portable Skid Tester |
Contact |
| 345 |
Determining the Quantity of Asphalt Rejuvenating Agent Required for an Asphaltic Pavement |
Contact |
| 346 |
Determining the Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin Film Oven Test) |
Contact |
| 351 |
Determining the Percent of Residue of Emulsified Asphalt Rejuvenating Agents |
Contact |
| 354 |
Evaluating the Expansive Potential of Soils Below Rigid Pavements (Third-Cycle Expansion Pressure Test) |
Contact |
| 356 |
Determining Overlay Requirements by Pavement Deflection Measurements |
Contact |
| 358 |
Determining Permeability of Thin Membranes Under Asphalt Concrete |
Contact |
| 359 |
Predicting K-Values of Existing Asphalt Concrete Roadways from Pavement Deflection Measurements |
Contact |
| 360 |
Surface Abrasion of Compacted Bituminous Mixtures |
Contact |
| 362 |
Determining Asphalt Content in Bituminous Mixtures by Vacuum Extraction |
Contact |
| 365 |
Micro-Recovery of Asphalt from Bituminous Cores and Samples of Loose Asphalt-Aggregate Mixtures |
Contact |
| 366 |
Stabilometer Value |
Contact |
| 367 |
Recommending Optimum Bitumen Content (OBC) |
Contact |
| 368 |
Determining Optimum Bitumen Content (OBC) for Open Graded Asphalt Concrete |
Contact |
| 370 |
Determining Moisture Content of Asphalt Mixtures or Mineral Aggregate Using Microwave Ovens |
Contact |
| 371 |
Resistance of Compacted Bituminous Mixture
to Moisture Induced Damage |
Contact |
| 373 |
Unconfined Compressive Strength of Lime Treated Soils and Aggregates |
Contact |
| 374 |
Determining Asphalt Durability Using the California Tilt-Oven Durability Test |
Contact |
| 375 |
Determining the In-Place Density and Relative Compaction of AC Pavement |
Contact |
| 377 |
Determining the Percent and Grade of Recycling Agent to Use for Hot Recycling of Asphalt Concrete |
Contact |
| 378 |
Percent and Grade of Recycling Agent to Use for Cold Recycling of Asphalt Concrete |
Contact |
| 379 |
Determining Asphalt Content of Bituminous Mixtures (Troxler Nuclear Gauge Model 3241) |
Contact |
| 380 |
Recovering Asphalt Materials by Modified (IA) Abson Recovery |
Contact |
| 381 |
Determination of Asphalt Binder Properties using a Dynamic Shear Rheometer |
Contact |
| 382 |
Determination of Asphalt Content of Bituminous Mixtures by the Ignition Method |
Contact |
